Rockwell Automation 20D Stegmann Feedback Option Board for PowerFlex 700S Drives - Manual

Installation Instructions
Stegmann Feedback Option Board for
PowerFlex
®
700S Drives
What This Kit Contains Verify that your kit contains the items listed in the following table. If your
kit does not contain the correct items, contact your Rockwell Automation
sales representative.
Tools That You Need
•
Phillips
®
screwdriver for M3 screws
•
POZIDRIV
®
screwdriver for M4 screws (for high power drives only)
•
Nut driver or wrench for M3 hex nut
•
Nut driver or wrench for M5 hex nut
Phillips ® is a registered trademark of Phillips Screw Company
POZIDRIV ® is a registered trademark of Phillips Screw Company
!
ATTENTION: To avoid an electric shock hazard, verify that the
voltage on the bus capacitors has discharged completely before
servicing. Check the DC bus voltage at the Power Terminal
Block by measuring between the +DC and -DC terminals,
between the +DC terminal and the chassis, and between the -DC
terminal and the chassis. The voltage must be zero for all three
measurements.
!
ATTENTION: HOT surfaces can cause severe burns. Do not
touch the heatsink surface during operation of the drive. After
disconnecting power allow time for cooling.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.
!
ATTENTION: The sheet metal cover and mounting screws on
the ASIC Board located on the power structure are energized at
(-) DC bus potential high voltage. Risk of electrical shock, injury,
or death exists if someone comes in contact with the assembly.
Quantity: Description
1 Stegmann Feedback Option circuit board
2 34 - pin “stacker” connectors
Important: The part number of the stacker connectors in Phase I drives is 313611.
The part number for the stacker connectors used in Phase II drives is 320669-Q04.
3 Screws with captive lock washers
3 Stand-offs (for Phase i drives only)