Afinia H479 3D - Manual (Page 8)

Afinia H-Series 3D Printer User’s Manual
8
Installing the Afinia H-Series 3D Printer
Attaching the Material Spool
Attach the Material Spool with these steps:
A. Connect the power adapter to the power
interface and turn on the power switch.
B. Install the ABS plastic spool holder and filament guide. Unscrew the lower right screw
from the left side of the Printer. Use this same screw to attach the spool holder with the
bottom right lip of the spool holder locked onto the printer’s corner and the top of the
holder mounted over the upper left screw.
C. Put the ABS Material Spool onto the holder with the end of the filament pointing up from
the back. Thread the filament through the Filament Guide at the top of the spool holder.
D. Insert the end of filament into one end of the Filament
tube. Feed the filament through the tube until about 4
inches of filament protrudes from the tube.