Yamato Scientific RE500 Evaporators, Rotary - Manual (Page 17)

15
Installation/Assembly
Gllassware
12. Connecting the cooling condenser and condenser holder
(B & C condenser only).
1. Connect the cooling condenser to the condenser connector and hold by the cooling condenser
clamp.
2. Insert the cooling condenser holder from the top of condenser, while fitting the other side
through the holder shaft. (For type C, be sure to insert the cooing condenser holder from the
bottom of condenser rather than top and then connect the condenser to the condenser
connector)
3. Fit the suction cock to type B or the cooling condenser lid to type C.
Cooling Condenser Clamp
Suction Cock Condenser Lid
Cooling Condenser Holder