Yamato Scientific RE500 Evaporators, Rotary - Manual (Page 15)

13
Installation/Assembly
Glassware
9. Set the cooling condenser nut, coil ring and vacuum seal to the condenser
or condenser connector.
1.Remove the cooling condenser nut on the left
side of the motor.
2.Connect the cooling condenser nut and then
coil ring to the condenser or condenser
connector (which ever applies).
3.Insert the vacuum seal to the condenser or
condenser connector (which ever applies).
*It is optional to put grease on the vacuum seal.
10. Connect cooling condenser or condenser connector to the motor.
Insert the steam duct into vacuum seal, put glass flange to the motor and fasten firmly the cooling
condenser nut.
＊ ＊ ＊ ＊ Be careful not to damage the vacuum seal when you insert steam duct into the vacuum
seal in case the damage could cause leak.
Glass Type A Glass Type B/C
Above : Fitting of Coil Ring and Vacuum Seal
Below : Fitting to Motor
Above : Fitting of Coil Ring and Vacuum Seal
Below : Fitting to Motor
● ● ● ●When you remove the coil ring from cooling condenser or condenser connector
Hook the coil ring by the attached hexagon wrench as shown in the left
picture in order to remove the ring easily from the cooling condenser or
condenser connector. However, be careful not to force too hard in case
the glass apparatus or coil ring might be damaged.
Coil Ring
Vacuum Seal
Coil Ring
Vacuum Seal