Yamato Scientific RE500 Evaporators, Rotary - Manual (Page 13)

11
Installation/Assembly
RE400/500
6. Set the Body at a stable place
Be sure to set the body at a stable place.
7. Fix the motor to the body.
1. Insert the motor bearing bar into the motor support clamp of the body, put D cut surface (flat
surface) of the bar perpendicularly to either 2 upper or side screws, and fasten 4 fix screws tightly
by using the attached hexagonal wrench (for M5).
Then, slant the motor to the right (about 45 °), and fix the finger screw of the motor tightly.
If you do not fasten the screws tightly, vibration may occur preventing accurate
measurements or the motor may fall causing the glass apparatus to break.
2. Remove the cooling condenser nut (the bigger nut with the coil ring) and coil ring when you fix the
motor.
Finger Screw Motor Support Clamp