Yamato Scientific RE500 Evaporators, Rotary - Manual (Page 12)

10
Installation/Assembly
RE200
4. Fix the motor to the motor support clamp.
1. Fit the motor bearing bar to the motor support clamp, and fasten the clamping screw tightly.
Put D-cut surface ( flat surface ) of the bar perpendicularly to the screw.
2. Slant the motor to the right (about 45 °) and fix the finger screw of the motor tightly.
If you do not fasten the screws tightly,
vibration may occur preventing accurate
measurements or the motor may fall causing
the glass apparatus to break.
5. Fix the controller to the support rod.
Fix the controller to the support rod by attached clamping screw.
Bearing bar
Motor Support Clamp
Clamping Screw
Controller
Finger Screw