Yamato Scientific DVS602 Constant Temperature Drying Oven - Manual (Page 19)

17
4. Operating procedures
Operating procedures (fixed temperature operation)
How to start fixed
temperature
operation
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
PROGRAM
1. Turn power ON. (Turn the ELB to ON.)
When power is turned ON, the initial values will be displayed for
about four seconds, then the initial screen will appear and the
current bath temperature, operation mode character and the
overheat prevention set temperature are displayed on each of the
displays.
MEASURED TEMP. display: Indicates the present bath temperature and various
characters.
Set temperature display: Indicates the set temperature and various characters.
Overheat prevention set temperature display: Indicates the set temperature for
the overheat prevention device.
For operation mode characters, see section page 11.
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
MEASURED TEMP.
℃
HEATER
ALARM
AUTO STOP
AUTO START
ENTER
SET
TEMP.
OVER TEMP.
PROTECTOR
FIXED TEMP.
RUN
STOP
SUB
MENU TIMER FIXED
TEMP. PROGRAM
PROGRAM
2. Selecting an operation mode
Press the FIXED TEMP. key to display the fixed temperature
operation mode on the SET TEMP. display.
Display the character Fix .
3. Setting the temperature
Press the FIXED TEMP. key again.
The character SV that indicate a set temperature is
displayed on the MEASURED TEMP. display on which the current
set temperature flashes and the FIXED TEMP. lamp flashes.
Set a temperature using the ▼▲ keys.
4. Starting operation
Press the RUN/STOP key for about one second. Operation starts
and status of the FIXED TEMP. lamp changes from flashing to
illuminated.
5. Stopping operation
Press the RUN/STOP key for about one second. Operation stops,
the FIXED TEMP. lamp goes off and the screen switches to the initial
setting screen.
When you want to
correct setting
errors or confirm
settings When you made a mistake during setting or reconfirm settings you
made, press the FIXED TEMP. key again to resume setting.
When you want to change set temperature during operation, press the
FIXED TEMP. key to enter the setting mode and change the set
temperature. After change has been made, press the ENTER key to
complete the process.