beautypg.com

Perating, Nvironment, Isposal of the – Wood’s Powr-Grip EL Series User Manual

Page 12: Ifter

background image

Rev 0.2/12-12

10

ELWC, etc: #35003

• 1" [2.5 cm] is the maximum allowable thickness of loads at the maximum weight (see

SPECIFICATIONS: Load Capacity).

3

However, allowable thickness increases as load weight

decreases. If necessary, contact Wood’s Powr-Grip for help in determining the maximum
thickness permitted when handling any specific load.

Note: Vacuum pads can stain or deform load surfaces with light colors or soft coatings. The

operator should test such surfaces for detrimental effects before using vacuum pads on them.

O

PERATING

E

NVIRONMENT

The operator must determine whether the Eazi Lifter is intended to be used in each work

environment, in accordance with the following restrictions:

WARNING: Never use Eazi Lifter in dangerous environments.

• This Eazi Lifter is not intended for use in any environment that is inherently dangerous to the

operator or likely to compromise the Eazi Lifter's ability to function. Environments containing
explosives, caustic chemicals and other dangerous substances must be avoided when using

the Eazi Lifter.

• Using the Eazi Lifter in wet environments may require the operator to take special precautions:

Moisture on contact surfaces of the load or vacuum pads diminishes the slip resistance,

thereby reducing the lifting capacity (see MAINTENANCE: V

ACUUM

P

AD

M

AINTENANCE

: Friction

Coefficient).

WARNING: Moisture reduces slip resistance of vacuum pads.

Although the Eazi Lifter's exterior surfaces can tolerate some exposure to water vapor, they
are not designed to be waterproof. Submerging the Eazi Lifter or using it in rain may damage

its components; these and similar conditions must be avoided. Make sure the Eazi Lifter is
thoroughly dried after any exposure to moisture.

• Never attempt to lift loads in windy conditions that may cause the load to swing out of control.

!!-CE-!! If the Eazi Lifter is employed in a construction area, CE Standard EN 13155 requires

the use of a secondary positive holding device, such as a sling system, designed to support
the load in case of a vacuum failure.

WARNING: Where CE Standards apply, secondary positive holding device is

required for lifting loads in construction zones.

D

ISPOSAL OF THE

L

IFTER

After the Eazi Lifter has reached the end of its service life, you must dispose of the lifter in

compliance with all local codes and regulatory standards that are relevant for the geographical
region.

3

The maximum allowable thickness is established to ensure the center of the load weight is not too far from the face of the pad.

In the case of typical windows, this requirement would apply to the total thickness of the panes of glass, not the thickness of the
framework.