UVP HEPA/UV PCR Systems - Manual (Page 7)

HEPA/UV3 PCR Workstation and Cabinet Page 7
Top Assembly and Shelf Assembly
1. Rest the top assembly on top of the unit.
WARNING: Ensure that the unit is not plugged in.
2. Connect the bottom and top assembly wires together according to their labels, matching wire “A”
with wire “A,” wire “B” with wire “B” and so forth, until all labeled wires are connected. Connect the
wires by joining the male and female red connectors located on the ends of each wire. Then,
connect the two unlabeled green/yellow ground wires together using the red connectors.
3. Slide the top assembly down so that the Makrolon
®
panels are inside the top assembly channels.
Make sure that the back flange of the top assembly is positioned between the inner back and the
outer back panel. Slide the wires into the space between the inner and outer back panels. Secure
and tighten the top assembly to the back panel with screws, pushing from the back to ensure the
screws are secure.
4. Slide the shelves into the shelf bracket.
Flange
Screw locations
Shelf bracket
Top Assembly