UVP HEPA/UV PCR Systems - Manual (Page 4)

HEPA/UV3 PCR Workstation and Cabinet Page 4
Assembling the PCR System
Carefully remove the unit from the packaging materials. Follow the assembly instructions provided
in this manual. NOTE: Place the PCR base on a level surface large enough to accommodate the
entire base. The surface must be level to ensure proper alignment of the Makrolon
®
panels.
Tools Required
•
Philips head screwdriver
•
Flathead screwdriver
•
Gloves, to reduce transfer of fingerprints to PCR components
Two people are recommended for assembly or lifting of this equipment.
NOTE: Assembly drawings show the 95-0436-01 UV2 PCR Cabinet. These instructions apply for all PCR
models.
Outer Back Panel
NOTE: The outer and inner back panels and shelf bracket are assembled at the factory for
shipping purposes. The metal Makrolon
®
frames (2) are taped to the panels. Disassemble the
back panels/shelf bracket and remove the protective film prior to completing the assembly
instructions below.
1. Attach the outer back panel to the base with two screws as shown below.
Do not tighten the screws at this time.
Screw
Screw
Base
Outer back panel. Note the notch in
the top of the panel allows room for
the wires.