UVP HEPA/UV PCR Systems - Manual (Page 5)

HEPA/UV3 PCR Workstation and Cabinet Page 5
Inner Back Panel
1. Position the wires so that they run between the inner back panel and the outer back panel up to the
top for later connection to the top assembly.
2. Position the inner back panel so that the screw holes are aligned with the outer back panel. Attach
the inner back panel to the outer back panel with four (4) screws. Make sure the wires come out of
the cutout in the back panel, as shown by the red circle below.
3. Secure the shelf bracket in front of the inner back panel using:
a. Eight (8) screws in the Workstation or
b. Six (6) screws in the Cabinet
NOTE: Two people are required to hold the panels in place and insert the screws.
Do not fully tighten screws at this time.
Inner back panel
Bracket
Position the inner
panel so that the
edge of the frame
rests against the
stainless steel base
Cutout for wires