USG Compässo Standard Suspension Trim System - Manual (Page 2)

Manufactured by USG Interiors, Inc.
550 West Adams Street
Chicago, IL 60661 IC588/4-11
© 2011, USG Interiors, Inc.
Printed in U.S.A.
Tip Sheet
C OMPÄSSO Standard Clip Installation
Install a C OMPÄSSO clip on the end of each tee. First, slide the clip
onto the top of the grid…
Clip installation where C OMPÄSSO island has perimeter grid.
Rotate clip 90 degrees and screw-attach to bulb of grid.
Snap into C
OMPÄSSO Trim.
Note: If a grid attachment clip occurs at a splice, the system is designed to accommodate both the splice and the attachment clip at the same point.
Technical Service
800 USG.4YOU
Website
usg.com
Samples/Literature
888 874.2450
Samples/Literature E-mail
[email protected]
Samples/Literature/Fax
888 874.2348
Customer Service
800 950.3839
Note
All products described here may not be
available in all geographic markets and are
subject to change without notice. Consult
your local sales office or representative for
information.
Trademarks
The following are trademarks of USG
Interiors, Inc. or a related company:
C
OMPÄSSO , USG, USG in stylized letters.
Notice
We shall not be liable for incidental or
consequential damages, directly or
indirectly sustained, nor for any loss caused
by application of these goods not in
accordance with current printed instruction
or for other than intended use. Our liability
is expressly limited to replacement of
defective goods. Any claim shall be deemed
waived unless made in writing to us within
thirty (30) days from the date it was or
reasonably should have been discovered. Safety First!
Follow good safety/industrial hygiene
practices during installation. Wear
appropriate personal protective equipment.
Read MSDS and literature before
specification and installation.