USG Durock Cement Board - Manual (Page 8)

Manufactured by
United States Gypsum Company
550 West Adams Street
Chicago, IL 60661
Trademarks
The following trademarks used herein
are owned by United States Gypsum
Company: D urock , USG, USG in
stylized letters.
Note
Products described here may not be
available in all geographic markets.
Consult your United States Gypsum
Company sales office or representative
for information.
Notice
We shall not be liable for incidental and
consequential damages, directly or
indirectly sustained, nor for any loss
caused by application of these goods
not in accordance with current printed
instructions or for other than the
intended use. Our liability is expressly
limited to replacement of defective
goods. Any claim shall be deemed
waived unless made in writing to us
within thirty (30) days from date it
was or reasonably should have
been discovered.
Safety First!
Follow good safety/industrial hygiene
practices during installation. Wear
appropriate personal protective
equipment. Read MSDS and literature
before specification and installation.
WARNING!
Dust can contain silica. Prolonged and
repeated breathing of silica dust can
cause lung damage and cancer. If cutting
with a power tool, use a wet or vacuum
saw to reduce the amount of dust
generated. Dust can be corrosive to eyes,
skin, and respiratory tract. Contact can
cause severe chemical burns. Wear eye,
skin and respiratory protection. If eye
contact occurs, flush immediately with
water for 30 minutes. If ingested,
call physician. Product safety information:
800-507-8899 or usg.com
Customer Service: 800 USG-4-YOU
(800 874-4968).
For warranty or product
information and literature:
800 USG.4YOU (874-4968)
usg.com
CB237EN/rev. 11-11
©2011 United States Gypsum Company
Printed in U.S.A.