USG Geometrix User Manual

Page 2

Step 7
Use pliers to flatten the side edges of the
remaining scored section.

Step 8
Use a hammer to finish flattening these side
edges. Be careful not to mar the panel face.

Step 9a
Use a straightedge to bend up this flattened
section at the score line. You may need to
finish this step by hand to completely form
the new side edge.

Step 9b

Step 10
Mark where the new side edge extends
beyond the panel perimeter.

Step 12a
Install field-cut panel.

Step 12b

Step 11
Trim away and discard this excess
material.

Note:
Be especially careful when field-cutting
panels that do not butt to a wall.

Note
All products described here
may not be available in all
geographic markets and are
subject to change without
notice. Consult your local
sales office or representative
for information.

Trademarks
The following are trademarks of
USG Interiors, Inc. or a related
company: G

EOMETRIX

, USG.

Notice
We shall not be liable for
incidental or consequential
damages, directly or indirectly
sustained, nor for any loss
caused by application of these
goods not in accordance with

current printed instruction or
for other than intended use.
Our liability is expressly limited
to replacement of defective
goods. Any claim shall be
deemed waived unless made
in writing to us within thirty
(30) days from date it was or
reasonably should have been
discovered.

SAFETY FIRST!
Follow good safety and industrial
hygiene practices during handling
and installation of all products
and systems. Take necessary
precautions and wear appropriate
personal protective equipment
as needed. Read material safety
data sheets and related literature
on products before specification
and/or installation.

Manufactured by
USG Interiors, Inc.
125 South Franklin Street
Chicago, IL 60606

Sales Representative 877 874.4200
Customer Service 800 950.3839
Samples, Literature 888 874.2450
Technical Service 800 USG.4YOU
Web Site www.usg.com

Page 2 of 2