USG Geometrix - Manual

Field Cutting and
Forming Panels Geometrix ™
1. 1. 1.
1. 1. 1.
1.
Step 3
Score panel face between these points with
a sharp utility knife and straight edge.
Step 5
Snip the side edge of the panel at the ends
of each score line. Step 6a
Bend and break off the section to be
discarded. Use a straightedge to avoid
deforming the panel face. 6b
Step 4a
Make a second score parallel to the first
with 1
Љ to 3Љ between. Material between
the score lines will be used to form a new
side edge. The rest will be discarded.
Step 4b
Step 1
Measure grid opening. Step 2a
Transfer dimensions to panel. Step 2b
Page 1 of 2