Regency Horizon HZ30E Small Gas Fireplace - Manual (Page 46)

46
Regency Horizon™ HZ30E-1 Gas Fireplace
INSTALLATION
REFLECTIVE PANEL INSTALLATION
1) Remove the faceplate and glass door if already installed - see
manual for instructions.
2) Install the back panel fi rst. Tilt the panel forward - position the bottom
of the panel fi rst. Use care not to scratch or mar the panel on the
pilot shield.
3) Install the left side panel - secure in position with one panel clip and
one screw, as shown in the diagram below.
4) Install the right side panel - secure in position with one panel clip
and one screw.
5) Reinstall glass door - reinstall faceplate.
6) Final installation
Before installation, panels must be handled and cleaned as per instructions noted below:
Black Enamel Panels
•
Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
* All hand and fi nger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any
fi ngerprints before applying heat to the unit.
Failure to do this will result in burn stain on panels which you will be unable to remove. Not protected by product warranty.