Regency Horizon HZ30E Small Gas Fireplace - Manual (Page 40)

40
Regency Horizon™ HZ30E-1 Gas Fireplace
INSTALLATION
RECEIVER WALL SWITCH
(Included with Unit)
1) Run the supplied 10' of the wire harness through the right or left side gas
inlet opening- connect the ON/OFF wire harness. Be careful not to damage
wire.
2) Choose a convenient location on the wall to install the receiver and the
receptacle box (protection from extreme heat is very important). Run wires
from the fi replace to that location.
3) Connect the wire to the receiver wall switch and install into the low voltage
receptacle box.
Optional
REMOTE CONTROL
Use the Regency ® Remote Control approved for this unit. Use of other systems
may void your warranty.
The remote control comes with a hand held transmitter, a receiver is supplied
with the unit.
Profl ame GT remote control (HZ30E Surefi re) 946-700
RF remote, ON/OFF Thermostat, ON/OFF Flame Control
Large blue backlit LCD screen with temperature display. (Receiver comes with
unit, not included with remote.)
Profl ame GTMF remote control (HZ30E Surefi re) 946-703
RF remote, ON/OFF Thermostat, ON/OFF Flame Control (Note: HZ30E has
no fl ame adjustment)
ON/OFF fan control with 3-stage adjustment,. Requires a fan (if not included),
to be installed for fan function to operate.
Large blue backlit LCD screen with temperature display. (Receiver comes with
unit, not included with remote.)
CAUTION
Do not wire millivolt
remote control wires
to 120V wire.
CAUTION
Do not wire millivolt
wall switch wires
to 120V wire.