Regency Horizon HZ30E Small Gas Fireplace - Manual (Page 42)

42
Regency Horizon™ HZ30E-1 Gas Fireplace
INSTALLATION
GTMF REMOTE INSTALLATION
3) Remove the glass door.
a) Remove the 2 screws shown below at the bottom of the glass
door .
b) Swing the door out 45 o from the bottom and lift up and out.
Faceplate
(4pc style
shown)
Glass Door
120 Volt AC power is needed for the fan. The fan can be hard wired if desired.
The receptacle box should be installed on the right hand side of the unit
by a qualifi ed electrician. The neutral (wider) slot of the polarized receptacle
should be at the top.
Unit must be grounded at all times. Do not cut the ground terminal off
under any circumstances.
1) Shut off the gas and power supply to the unit.
2) Remove the faceplate or door frame by lifting it up off the glass door.
a) If the the unit and facing material is already installed - continue to step
3.
b) If this is a new install - proceed to step 8b
4) Remove the burner tray cover by lifting up and out as shown below.
* Prior to removing burner - remove crystals, pebbles, spa stones and inner
panels - if installed.
5) Loosen 2 screws at the back of the burner to release it.
6) Remove the burner by sliding it to the right - then lift out.