Regency Hampton HI300 Medium Wood Insert - Manual (Page 14)

14
Hampton HI300 Wood Cast Insert
installation
918-967 05/02/11 1
HI300
OVERSIZE CAST FACEPLATE INSTALLATION
Stop! Read Carefully.
Enamel & Cast components are very fragile. Use extreme care when handling.
1) Secure the Side Mounting Brackets (packaged with Faceplate) to the
left and right side of the fi rebox using 2 bolts per mounting bracket
as shown in the diagram below. Bolts are pre-installed on unit.
Leave bolts loose until fi nal adjustment is made.
Side Mounting
Bracket
Backside of Unit Shown.
Backside of Unit & Faceplate Shown.
2) Secure the Left and Right Side Faceplate to the fi rebox by aligning
the Mounting Holes with the Side Mounting Brackets taking care to
align vertically while each side rests on the hearth. Secure using 2
bolts per bracket.
Side Mounting
Bracket
Mounting
Hole
Right Side Face-
plate
Left Side Face-
plate
3) Place 1- 1/4" x 1" Hex head bolt with 2 washers in Mantel Top
Spacer location shown below.
4) Place Mantel Top onto the top of the fi rebox.
Mantel Top
Mantel Top Spacer
Right Side
Cast
With the Mantel Top in place check to make sure there is no gap
between the Mantel Top Spacer and the underside cast of the Mantel
Top. If there is a gap present you will need to lower that side cast by
loosening 2 bolts, see side cast adjustment section for bolt location
(check to see if level).
FACEPLATE CONTENTS LIST
Qty Description
1 Left Side Faceplate
1 Right Side Faceplate
1 Top Faceplate
2 Side Mounting Brackets
2 1/4" - 20 x Hex Nuts
2 1/4" - 20 x 1" Hex Head Bolts
2 1/4" Flat Washers
2 47" Insulations
1 8 mm gasket
oVersize cast faceplate installation