Regency Hampton HI300 Medium Wood Insert - Manual (Page 13)

Hampton HI300 Wood Cast Insert
13
installation
12/23/10 918-300g
HI300
CAST FACEPLATE
INSTALLATION
8) Location of Insulation:
a) Place 1 piece of Insulation behind the Mantel Top.
b) Cut the second piece of Insulation in half, then install behind both
the Left and Right Sides as shown.
9) The unit may now carefully be slid into fi nal position.
Insulation
Rear View of Unit
RECOMMENDED MEASUREMENTS
FOR SETTING SIDE CASTS
Stop! Read Carefully.
Enamel & Cast components are very fragile.
Use extreme care when handling.
Right Side
Cast
Left Side
Cast
1/4" (approx.) between both
sides of door and cast.
Ashlip
1/8" - 1/4" (approx.) for both sides,
between ashlip and bottom of side cast.
4-1/2" - 4-3/4" boths sides rear inside edge to fi rebox.
Important: Verify gap between cast and door did not
change when rear adjustments have been made.
Carefully open door slowly, to ensure that the door does
not rub against cast sides.
* These are just recommended measurements.
Page 3 of 3