8 dc voltage input – SATEC SA300 ezPAC Installation Manual User Manual
Page 27
Chapter 2 Installation
24
2.2.8
DC Voltage Input
SA300 models are provided with one DC voltage input, which can be used for measuring of substation storage
battery voltage (see Figure 2-17a), or for measuring unit power supply voltage (see Figure 2-17b). Copper
wiring 1.5-2.5 mm
2
(15 –13 AWG) should be used.
Figure
2-17 a) and b) DC Voltage Measurement Input Connection
See also other documents in the category SATEC Equipment:
- AX-8 (15 pages)
- BFM136 (70 pages)
- C191HM (63 pages)
- C192PF8-RPR (75 pages)
- EDL175 (23 pages)
- EM132-133 Manual (152 pages)
- EM132-133 Quick Start (10 pages)
- ETC2002 (57 pages)
- EM720 Installation Manual (32 pages)
- EM720 Operation Manual (218 pages)
- EM920 Installation Manual (37 pages)
- EM920 Operation Manual (225 pages)
- SA300 ezPAC Operation Manual (182 pages)
- PAS (27 pages)
- PM130 PLUS Manual (159 pages)
- PM130 PLUS Quick Start (4 pages)
- PM135 Manual (166 pages)
- PM135 Quick Start (4 pages)
- RDM172 Manual (135 pages)
- RDM172 Quick Start-1 (10 pages)
- RDM172 Quick Start-2 (14 pages)
- PM174 Manual (149 pages)
- PM174 Quick Start (11 pages)
- PM175 Manual (168 pages)
- PTS175 Manual (12 pages)
- PM175 Quick Start (13 pages)
- PM180 Installation Manual (33 pages)
- PM180 Operation Manual (184 pages)
- RGM180 (24 pages)
- PM296 (77 pages)
- RSC232 (10 pages)
- 1771DB (17 pages)
- SLC500 (24 pages)