Salsbury Industries 90000 Series Plastic Lockers (90168,90368 Ten Tier) User Manual

Page 3

Plastic Lockers – 90000 Series

Models 90168 & 90368 Ten Tier

Assembly Instructions

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering

lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Step 11. Install one (1) latch plate with two (2) screws for each of
the ten (10) doors inside the front edge of the left hand side panels.

Step 11. Install screws and hole covers where side panels join to top

panels and base panel. There are 22 screws and hole covers on
each of the two sides of the assembly (44 in total).

Step 12. Install the sloping hood (optional) to the top of each locker

column by aligning six (6) locating tabs with the topmost panel.
Press locating tabs into place. Illustration shows sloping hood before
pressing tabs into place. Plastic filler strips shown in step 6 are not
required on units with a sloping hood and can be discarded.

Step 13. Install placards (optional) in the indentation near the top of
each door.

Step 14. If two (2) or more lockers are to be installed side by side,
the lockers should be fastened together with the four (4) nuts and

long screws provided. Select any two (2) holes toward the front and
any two (2) holes toward the rear. The illustration below shows the
20 holes that are available. The lower illustration shows the inside
view of a hole and screw.

The assembly of the plastic lockers is now complete.

SLOPING

HOOD

INSIDE VIEW

OF HOLE

AND SCREW

HOLES

SCREWS

COVERS

LATCH

PLATE

LATCH

PLATE