Salsbury Industries 90000 Series Plastic Lockers (90168,90368 Ten Tier) User Manual

Page 2

Plastic Lockers – 90000 Series

Models 90168 & 90368 Ten Tier

Assembly Instructions

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering

lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Step 7. Stack the four (4) upper units onto the lower unit. Press all
units firmly together. Use a soft rubber mallet if necessary.

Step 8. Insert one (1) of five (5) divider panels in between each of

the horizontal panels previously installed. The panels slide in
grooves in the side panels and may need the use of a soft rubber
mallet to fully engage the two small latch pins into the holes in the
front edge of the side panels.

Step 9. Attach the plastic oval lock plate to the front of the ten (10)
doors with two (2) screws from the rear of the door. Do not over
tighten. Insert the stainless steel hasp through hole in front of doors

making sure cutout is facing downward. Secure by threading nut
provided onto it from the rear. Insert lock knob through hasp from
front of door making sure hole in lock knob is positioned downward.
Attach cam to rear of lock knob shaft with screw provided. Be sure
the cam is pointing horizontally toward the outside of the door when

the lock knob is positioned vertically, and is properly engaged with
the square shaft on the end of the lock knob.

Step 10. Fasten the ten (10) hinges (one (1) for each of the ten (10)
doors) provided in the hardware package securely to each hinge
position with the screws provided as shown below. Fasten each of
the ten (10) doors to the appropriate hinge. Ensure that the molded

pins in the upper and lower right corners of each door are engaged in
the mating holes in the right front corners of each horizontal panel.
The panels will have to be slightly separated vertically to enable the
pins to mate with the holes.

PANEL WITH

FILLER STRIPS

(IF NO OPTIONAL

SLOPING HOOD)

BASE PANEL

(THICKER)

CAM

LOCK

PLATE

HASP

LOCK

KNOB

NUT

ALL

UNITS

STACKED

SCREWS

(2)

NAMEPLATE

(OPTIONAL)

SCREW

DOOR

HINGE

DIVIDER

PANEL

(5 PLACES)

DOOR

HINGE