Salsbury Industries 93000 Series Plastic Lockers (93168,93368 Triple Tier) User Manual

Page 3

Plastic Lockers – 93000 Series

Models 93168 & 93368 Triple Tier

Assembly Instructions

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering

lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Step 11. Slide the shelves (optional) into the slots in the locker side

panels. There are three (3) slots available for shelves in each of the

compartments.

Step 12. Install the sloping hood (optional) to the top of each locker

column by aligning six (6) locating tabs with the topmost panel.

Press locating tabs into place. Illustration shows sloping hood before
pressing tabs into place. Plastic filler strips shown in step 6 are not

required on units with a sloping hood and can be discarded.

Step 13. Install placards (optional) in the indentation near the top of
each door.

Step 14. If two (2) or more lockers are to be installed side by side,

the lockers should be fastened together with the four (4) nuts and

long screws provided. Select any two (2) holes toward the front and
any two (2) holes toward the rear. The illustration below shows the

12 holes that are available. The lower illustration shows the inside

view of a hole and screw.

The assembly of the plastic lockers is now complete.

SLOPING

HOOD

INSIDE VIEW

OF HOLE

AND SCREW

SHELF