Salsbury Industries 93000 Series Plastic Lockers (93168,93368 Triple Tier) User Manual

Page 2

Plastic Lockers – 93000 Series

Models 93168 & 93368 Triple Tier

Assembly Instructions

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering

lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Step 7. Stack the two (2) upper units onto the lower unit. Press all

units firmly together. Use a mallet if necessary.

Step 8. Install screws and hole covers where side panels join to top

panels and base panel. There are 14 screws and hole covers on

each of the two sides of the assembly (28 in total).

Step 9. Attach the plastic oval lock plate to the front of the three (3)

doors with two (2) screws from the rear of the door. Insert the

stainless steel hasp through hole in front of doors making sure cutout
is facing downward. Secure by threading nut provided onto it from

rear. Insert lock knob through hasp from front of door making sure

hole in lock knob is facing downward. Attach cam to rear of lock

knob shaft with screw provided. Be sure the cam is pointing toward
the outside of the door and is properly engaged with the square shaft

end of the lock knob.

Step 10. Fasten the six (6) hinges (two (2) for each of the three (3)

doors) provided in the hardware package securely to each hinge
position with the screws provided as shown below. Fasten each of

the four (4) doors to the appropriate pair of hinges.

PANEL WITH

FILLER STRIPS

(IF NO OPTIONAL

SLOPING HOOD)

BASE PANEL

(THICKER)

CAM

LOCK

PLATE

HASP

LOCK

KNOB

NUT

ALL

UNITS

STACKED

SCREWS

(2)

NAMEPLATE

(OPTIONAL)

SCREW

HOLES

SCREWS

COVERS

DOOR

HINGE