Robustel W800 - Manual (Page 34)

Robustel GoFixed W800 User Guide
RT_W800_UG_v02.00
04.11.2011 Page 33 /59
Confidential
3.6.8 QoS Configuration
Please go to path: Network ‐> QoS Configuration page to enable Queue Management Configuration. If Enable QoS
checkbox is selected, a default DSCP mark should be chosen to automatically mark incoming traffic without reference
to a particular classifier. Click Apply/Save button to save.
Note: If Enable QoS checkbox is not selected, all QoS will be disabled for all interfaces; The default DSCP mark is used
to mark all egress packets that do not match any classification rules.
Please click QoS QUEUE button to enter the QoS Queue setup page, then click Add button. This screen allows you to
configure a QoS queue and assign it to a specific layer 2 interface. The scheduler algorithm is defined by the layer 2
interface. Click Apply/Save to save and activate the queue.
Please click QoS Class button to enter QoS Classification Setup page, then click Add button to configure network
traffic classes. This screen creates a traffic class rule to classify the upstream traffic, assign queue which defines the
precedence and the interface and optionally overwrite the IP header DSCP byte. A rule consists of a class name and
at least one condition. All of the specified conditions in this classification rule must be satisfied for the rule to take
effect. Click Apply/Save to save and activate the rule.