Robustel W800 - Manual (Page 18)

Robustel GoFixed W800 User Guide
RT_W800_UG_v02.00
04.11.2011 Page 17 /59
Confidential
Chapter 3. Operate the Gateway
3.1 Default Configuration
The Gateway has pre‐configured with the VCI/VPI which is in common use. The default dial‐up mode is bridge
encapsulation. For bridge mode, no need to configure any more parameter. However, the third party dial‐up software
is needed for connection with the Internet.
3.2 Configuration
The default IP address for Gateway is: 192.168.1.1; the Subnet Mask is：255.255.255.0.
Users can configure the Gateway through an Internet browser. The Gateway can be used as gateway and DNS server;
users need to set the PC’s TCP/IP protocol as follow:
1. Set the PC IP address at same segment of the Gateway such as set the IP address of the network card to one of
the “192.168.1.2” to “192.168.1.254” excluding “192.168.1.1”.
2. Set the PC’s gateway the same IP address as the Gateway’s.
3. Set PC’s DNS server the same as Gateway’s IP address or that of an effective DNS server.
3.3 Log In the Gateway
Power on to start the Gateway, making sure your PC can PING via LAN port of Gateway (the factory default IP is
192.168.1.1), then run IE. Inputting http://192.168.1.1 in the address column, press ENTER, and authentication
interface will pop up as below: