BT 1020 - Manual (Page 9)

5. On the handset:
Screen prompts on the handset will help guide you through
the registration process – it’s easy!
• REGISTER TO HUB
will appear on screen. Press OK .
PRESS AND HOLD HUB BUTTON
will then appear on screen.
Press and hold the wireless association button on the back or
side of the Hub for 3 seconds (the phone light on the Hub will
then flash), then you can release the button.
• Press OK and place the handset in the charger connected to
the Hub. Once the handset and charger cradle are in the Hub,
REGISTERING
,
PLEASE WAIT
appears on screen.
DO NOT REMOVE THE HANDSET UNTIL YOU GET A
CONFIRMATION MESSAGE.
If registered successfully you should see:
HANDSET REGISTERED
.
If unsuccessful then
REGISTRATION FAILED
will appear and
you will have to try the process again. You will be returned to
the please register screen.
If this fails, then please see the manual registration process
on page 60.
Getting started
9
Hub Phone 1020 – Issue 3 – Edition 1 – 05.10.07.07 – 8423
Battery performance
The charge capacity of rechargeable
batteries will reduce with time as they
wear out, giving the handset less
talk/standby time.
Eventually they will need to be
replaced. Please ensure you use the
same mAh rating for battery
replacement to the batteries that
were provided when you received
the handset.
Talk/Standby time
In ideal conditions, the handset
batteries should give about 7 hours
talk time or 100 hours standby.
Note that new batteries do not reach
full capacity until they have been in
normal use for several days.
8423 Hub Phone 1020 Iss.3 [1] 12/10/07 12:25 Page 9