BT 1020 - Manual (Page 65)

Software upgrades
Automatic software upgrade
Your BT Home Hub checks regularly for handset software
upgrades. If there is a new version of software available it will send
a message to any registered handsets needing to be upgraded.
If you have handsets located around the home you will need
to place the charging cradle and phone into the front of the
hub to receive the upgrade.
When the handset display shows
NEW SOFTWARE. DOWNLOAD NOW?
.
You can either select OK to upgrade immediately or select
Later .
The message will be displayed again 24 hours later. If you
choose to upgrade the display will show
PLEASE WAIT
, for a
few seconds. The handset then needs to be placed within the
cradle connected to the Hub.
During download, once it is on the charger, the display shows
DOWNLOADING, LEAVE HANDSET IN CHARGER...
. The
backlight may turn off but do not remove the handset from
the charger
. Leave handset in charger.
65
Hub Phone 1020 – Issue 3 – Edition 1 – 05.10.07.07 – 8423
When the handset is on the charger
and the software is being upgraded,
you will not be able to use the handset
to receive calls.
Upgrades are free of charge and there
are no call fees associated with
upgrading. It's merely there to give
you the latest version of software
available. These may contain new
features or fixes.
If you have several handsets around
the home and want to upgrade all of
them, you don't need to change the
cradle in the Hub everytime. Just
upgrade all the handsets via the same
cradle within the hub.
Press Later if you decide not to
upgrade.
8423 Hub Phone 1020 Iss.3 [1] 12/10/07 12:26 Page 65