BT 1020 - Manual (Page 8)

Hub Phone 1020 – Issue 3 – Edition 1 – 05.10.07.07 – 8423
Getting started
8
2. Attach the cradle to the
BT Home Hub.
3. Slide open the battery
compartment on the back
of your BT Hub Phone
handset. Insert the 2 x AAA
rechargeable batteries
supplied. Slide back the
cover to close.
4. Place the BT Hub Phone 1020
into the cradle on the BT
Home Hub. You should hear a
beep when the handset has
been placed correctly. Charge
your handset for at least 24
hours on first charge before
using the phone.
IMPORTANT
The hub must be plugged into the
mains power socket at all times.
IMPORTANT
You can leave your handset in the
charging cradle attached to the BT
Home Hub if you wish or you can locate
your handset anywhere in your home,
using the mains power adapter and
charging cradle to keep the handset
charged. Occasionally you will need to
connect the handset to the charger
connected to the BT Home Hub to
receive new upgrades. You will be asked
to do this when there is new software.
Battery symbols
Battery charged
Battery half charged
Battery low
Battery empty
8423 Hub Phone 1020 Iss.3 [1] 12/10/07 12:25 Page 8