RKI Instruments SC-01 - Manual (Page 11)

SC-01 Operator’s Manual Description • 6
Alligator and Belt Clips
The SC-01 is available with two types of clips, the standard alligator clip
and the optional belt clip. Both are illustrated in Figure 3 below.
The alligator clip can be used to attach the SC-01 to clothing or a belt.
Teeth in the alligator clip’s jaws prevent the unit from slipping off. The belt
clip is used to easily clip the SC-01 on a belt.
Sensor Retainer
The sensor retainer is a tubular high impact plastic piece that retains the
sensor in the sensor socket. A rubber guard on the end of the retainer
protects the sensor from impact and an o-ring on the inside and on the
outside of the retainer seal the retainer to the sensor and to the SC-01
case. The end of the retainer is open to allow ambient air to reach the
sensor.
The sensor retainer slides over the sensor into the case and locks in place
with an eighth turn clockwise. Refer to “Replacing the Sensor” on page 34
for instructions to remove and install the sensor retainer.
Belt Clip
Alligator
Clip
Figure 3: Alligator & Belt Clips