RaySafe i2 Installation Manual User Manual
Page 18
18
RaySafe i2 Installation and maintenance manual – Installation
• one USb port available
• 1 gb of system memory available
• 40 gb hard drive with at least 15 gb of memory available
• Recommended screen resolution at least 1024 x 768
InStAllAtIon
follow the instructions below to install the dose viewer application and the cradle driver:
NOTE:
Do not connect the cradle to the computer until dose viewer is properly installed.
1. log on as local administrator on the computer on which to install dose viewer.
2. Insert the dose viewer Cd into the computer’s Cd drive. the dose viewer install wizard will start
automatically.
3. follow the instructions on the screen.
4. Check the box “launch dose viewer” to start the dose viewer application. the installation procedure will
finish by creating a dose viewer icon on the desktop.
5. Connect the cradle to the computer using the USb cable. dose viewer will detect the cradle within 30
seconds.
tRoUbleSHootIng
If the installation procedure fails, verify that:
• the system requirements are met.
• you are logged on as local administrator.
If windows does not automatically install the cradle driver when the cradle is first connected to a PC, you need
to install it manually. All the driver files are located on the installation Cd in the folder “Cradledriver”. these
files are also copied to the application installation folder when dose viewer is installed. when windows detect
a connected cradle and the dialog about driver installation is displayed, select to use the driver files located on
the Cd or in the application installation folder.