Brother DCP9040CN - Manual (Page 72)

64
Low Temperature The temperature of the machine
is too cold.
Increase room temperature to allow the machine
to operate.
No Belt Unit The belt unit is not installed. Install the belt unit. (See Replacing the belt unit
on page 108.)
No Drum Unit The drum unit is not installed. Install the drum unit. (See Replacing the drum
unit on page 101.)
No Paper The machine is out of paper or
paper is not properly loaded in the
paper tray. Do one of the following:
„ Refill the paper in the paper tray or MP tray.
„ Remove the paper and load it again.
No Tray The paper tray is not completely
closed. Close the paper tray properly.
No Waste Toner The waste toner box is not
installed. Install the waste toner box. (See Replacing the
waste toner box on page 113.)
Out of Memory The machine’s memory is full. Copy operation in progress
Do one of the following:
„ Press Mono Start or Colour Start to copy
the scanned pages.
„ Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
„ Clear the data from the memory. (See Out of
memory message on page 30.)
Print operation in process
Reduce print resolution. (See Advanced tab in
the Software User’s Guide on the CD-ROM.)
Print Unable XX The machine has a mechanical
problem.
Turn off the machine’s power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and then
try to print, copy or scan again.
Error Message Cause Action