MacDon R80 Rotary Disc - Manual (Page 54)

MAINTENANCE/SERVICE
Form # 169089
52
Model Year - 2009
e. If removing driveline disc;
1. Remove bolts (N).
2. Lift deflector (O) and driveline, and slide disc
(P) off spindle.
3. Clean spindle (G).
7.8.3.2 Disc Installation
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
CAUTION
Exercise caution when working around the
blades. Blades are sharp and can cause
serious injury. Wear gloves when handling
blades.
a. Position new disc (C) on spindle ensuring it is 90
degrees to the adjacent discs.
b. Install cover (B) and secure with four bolts (A).
c. Tighten bolts to 92 ft·lbf (125 N·m).
d. If installing disc with converging drum;
Standard Header
1. Position new disc (F) on spindle ensuring it
is 90 degrees to adjacent discs.
2. Install deflector (E) and secure with four
bolts (D).
3. Tighten bolts to 92 ft·lbf (125 N·m).
(continued next page)
N
P
O
C
B
A
D
E
F
16 FT SHOWN – 13 FT SIMILAR
G