MacDon R80 Rotary Disc - Manual (Page 50)

MAINTENANCE/SERVICE
Form # 169089
48
Model Year - 2009
7.8.1.2 Installation
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
DANGER
To avoid bodily injury or death from
unexpected start-up or fall of raised
machine; stop engine, remove key and
engage header lift cylinder stops before
going under machine for any reason.
CAUTION
Exercise caution when working around the
blades. Blades are sharp and can cause
serious injury. Wear gloves when handling
blades.
a. Locate forward end of rock guard (D) onto
cutterbar and engage tabs (F) onto cutterbar.
b. Raise aft end and install bolt (E) and nut.
NOTE
Longer bolt (E) is required for rock guards
at ends of cutterbar.
c. Install the two forward bolts (C) and nuts.
Tighten bolts.
d. Slip forward end of skid plate (B) into forward
end of rock guard (D).
e. Lift aft end and install two bolts (A) and nuts.
Tighten bolts from topside of cutterbar.
C
D
E
D
F
A
B
D
A