MacDon DWA for M Series - Manual (Page 7)

SET UP INSTRUCTIONS
169216 Revision E 5
C
Leave plastic plugs in
these two ports.
A
D
Draper drive block installation
To install the draper drive block, follow these
steps:
1. Move the left cab-forward platform to the
open position for access to the hydraulic
valve blocks. Ensure the platform latch is
engaged in open position.
2. Prepare DWA draper drive block:
• Install #12 ORB X #12 JIC fitting (A) to
port “R2” on DWA drive block.
• For M150/M200: Install regular #10
ORB X #10 JIC fitting (B
1
) to port “P” on
DWA drive block.
• For M155/M205: Install long #10 ORB
X #10 JIC fitting (B 2 ) to port “P” on DWA
drive block
3. Pre-install hose (D), supplied in kit, to fitting
(A) at DWA drive block to simplify assembly.
4. Install DWA drive block to windrower left
hand side frame with 3/8 in. serrated flange
head bolts (C). Route hose and fittings
(installed in step 3) through side frame,
pointing towards the windrower engine and
relief valve on block points to rear of
windrower.
M150/M200
SHORT FITTING
A
B
1
M155/M205
LONG FITTING
B 2