MacDon DWA for M Series User Manual

Page 10

SET UP INSTRUCTIONS

169216

Revision

Linkage installation

To install linkage, follow these steps:

1. Remove support (A) by removing nut (B).

2. Locate in hardware kit two carriage head

bolts, 3/4 x 4-1/2 in. long. Install bolts (C) in
windrower frame member between the
engine and caster wheels.
NOTE: Hoses will have to be moved to get
the bolts in place.

If mounting on an M150/M155 Windrower, go to
Step 3.
If mounting on an M200 Windrower, go to
Step 5.
If mounting on an M205 Windrower, go to
Step 7.

3. M150/M155: Remove the outer bolt and nut

from the front engine mount at (D) on both
left and right sides. Retain nuts for reuse.

4. M150/M155: Mount support (A) to

windrower frame with two 1/2 x 2-3/4 in. long
hex head bolts (F), flat washers (under bolt
heads) and nuts (E). These bolts replace the
engine mount bolts (D) removed in step 3.

• From underneath, install a 3/4 x 3-1/2 in.

long hex head bolt (G) with flat washer
(H) under bolt head. Secure with flat
washer, lock washer and nut on
top side.

• From top side, install a 3/4 x 5-1/2 in.

long hex head bolt (J) with flat washer
(H) under bolt head. Do not install nut
on bolt (J).

• Go to Step 8.

VIEW FROM UNDERNEATH WINDROWER

CAB END

