Paxton PROXIMITY compact slimline - Manual (Page 9)

Operation 9
All the LEDs will now flash. The unit is waiting to be Enrolled
Operation
PROXIMITY User tokens
This is the generic term used to describe all PROXIMITY devices created by Paxton Access. It covers
PROXIMITY ISO cards, PROXIMITY cards and PROXIMITY keyfobs.
All users of the system carry round the PROXIMITY User token. They can gain access through a door by
presenting the PROXIMITY User token to the reader. If the corresponding colour LED on the reader is lit
then the user can enter, assuming they have not been barred. If the card is accepted the green LED will flash
(the red and amber go out) and the door can be opened. If the card is not accepted then the red LED will
flash (all the other LEDs will go out) and the door will not open.
NOTE: The reader will beep each time a valid user card is used unless the system is set for silent operation.
PROXIMITY Shadow cards
To bar a user from entering an area guarded by a reader, the shadow card is used. Present the shadow token
to the reader (the reader beeps twice quickly). If the barred user now tries to use the reader to gain entrance,
their access will be denied. (The red LED will flash and the reader will emit a long low tone beep)
Programming PROXIMITY compact using function cards
The function cards are used to alter system features. Some function cards come in the starter pack and others
come in the function card pack.
Using function cards – Starter pack
PROXIMITY Order card
This card is not used in the programming of the system. It needs to be sent back with an order form if more
cards are needed. (See order form located in the card pack for more details)
PROXIMITY Enrolment card
This card is used to both initialise the system and re-enrol barred users. It can be presented once to initialise
the system after it is first powered up (See Initialising the system).
If a user has been barred from a door and needs to be re-Enrolled the PROXIMITY Enrolment card is used
with the user card.
Re-enrol the barred PROXIMITY User token by presenting the PROXIMITY Enrolment card to the reader.
(The LEDs will go out and the reader will beep continuously for 30 seconds) Present the PROXIMITY User
token within this time. (The reader will beep 4 times quickly and all the LEDs will come back on) Check
the PROXIMITY User token now works.
PROXIMITY Door Open Time card
The door open time card is used to adjust the time the door is held open for. To adjust the time:
• Present the PROXIMITY Door Open Time card to the reader (all the LEDs go out and the reader beeps
once per second)
• Present the PROXIMITY Door open Time Card to the reader (all the LEDs come back on)
The time between presenting the PROXIMITY Door open time card once and presenting it again sets the
time the door is held open for.
PROXIMITY Silent Operation card
This card is used to toggle the beeping of the reader on and off. By default the reader unit beeps PROXIMITY
token is presented to the reader. If necessary this beep can be silenced by presenting the PROXIMITY Silent
Operation card to the reader. When the card has been used the amber, green and red LEDs go out. Now the
reader will not beep when PROXIMITY tokens are used with the system. To make the unit beep again when
PROXIMITY tokens are used, simply present the PROXIMITY Silent Operation card to the reader again.
PROXIMITY Fail Open Release card
The output of the compact will be in 1 of 2 states, either supplying 12V or 0V dc to the lock continuously. By
default the compact is set-up for fail closed releases and so only supplies 12Vdc to the lock when a valid card
is used or when the exit button is pressed.
This card is used to toggle the output of the lock wires. Each time the card is presented to the reader the
output will change (the LEDs will go out and the reader will beep twice quickly)