Pavement Ends 51202 Replay - Manual (Page 7)

51202 pg 7 0612 Rev. B
Step Twenty-one
I
NSTALL
T
AILGATE
B
AR ON
V
EHICLE
Insert the Tailgate Bar into the mounts on each
side of the tailgate opening with the vinyl side
of the Rear Window toward the outside of the
vehicle.
Place Tailgate
Bar in mounts
Step Twenty-two
S
ECURE
R
EAR
W
INDOW
Z
IPPERS
To start the zipper, pull the two sliders as far down as pos-
sible on the driver’s side of the window in order to catch
the sliders to the pin.
Once the zipper is caught, start the top slider 1/2". Then
hold up the top of the window with one hand and close the
zipper with the other. The zipper is sandwiched between
layers of fabric in the corners so be careful not to catch
extra fabric in the zipper. Close the zipper.
Make sure that the Tailgate Bar is centered and is securely
in the mounts. Then tuck the fl aps on the Rear Window
under the top fabric.
Tuck Flaps
under top
Pull both sliders down as far
as possible to catch pin
Start
Zipper
Step Twenty
I
NSTALL
T
AILGATE
B
AR ON
R
EAR
W
INDOW
Remove the Rear Window from the box and lay
it fl at with the backing side up. Locate the Tail-
gate Bar set aside in Step One. The bar has a “C”
shaped channel, when viewed from the end. Orient
the bar with the round seal down and slide the “C”
channel on the retainer onto the tubed strip sewn
to the backing side of the Rear Window.
Rear Window -
Backing Side
Tailgate Bar
Tailgate
Retainer
Channel
Tubed
Strip