Multiquip SP6065 - Manual (Page 19)

19
O
PERATION
Before Starting
Before starting the saw, carefully follow the checklist below:
r
Securely install the Belt Guard (2).
r
Fully slide on the Collar Guard (3).
r
Verify that proper-sized Blade Guard (4) is fully installed on the Blade
Guard mounting tab.
r
Confirm the rear and side access panels (5) & (6) and engine protector
are in place.
r
Wear eye and hearing protection and protective clothing.
r
Adjust handle bars (1) for best operator control.
r
If a belt driven water pump is installed, do not run the engine with the
water pump switch on, unless the water supply is connected and
water is flowing.
Fig. 3 — Guards & Panels
1
4
3
2
5
6