MTS SWIFT 50 GLP Sensor Heavy Trucks - Manual (Page 43)

Road and Track Vehicles
SWIFT 50 GLP Sensors Installation 43
C. Install the cable conduit bracket onto the slip ring and secure the left
side with the four M5 X 0.8 mm fasteners.
Lubricate the fasteners with Molykote g-n paste and torque to 6.5 N•m
(56 lbf•in).
D. Align the hinge base to the holes on the right side of the conduit cable
bracket and slip ring. Rotate the hinge coupling and tube 90° to access
the top hole.
Secure the hinge base with the four M5 X 0.8 mm fasteners.
Lubricate the fasteners with Molykote g-n paste and torque to 6.5 N•m
(56 lbf•in).
E. Rotate the anti-rotate tube parallel to the cable conduit bracket.
Secure the cable to the cable conduit bracket using tie-wraps through
the holes in the bracket and two M5 x 0.8 mm fasteners.
Use tie-wraps to also secure the cable to the anti-rotate tube.
4. For front rim configurations (see the next figure): Attach the slip-ring
bracket with the slip ring, conduit bracket, and restraint tube to the
transducer.
A. The slip-ring bracket fits over the 9-pin connectors on the front of the
transducer at the locations labeled Board A and Board B. The slip-ring
bracket is similarly labeled to prevent connecting it the wrong way.
2