MTS Multipurpose Elite Test - Manual (Page 81)

12. Select the Minimum check box, and set the value to 0 sec.
13. Select the Maximum check box, and set the value to 20 sec.
6.2.8.0 Adding a Monitor Display to Track Profile Passes
This task adds a Variable Meter to the test. During the test, the Variable Meter increments each time the
profile plays out. The Variable Meter uses the variable you created in
Adding a Profile Activity on page 78 to
track the “Pass Counter” keyword in the profile.
1. Click the Test-Run Display tab.
2. In the Toolbox panel, note the various monitor displays available. From the Variables list, select the
Variable Meter.
3. Drag the Variable Meter icon to the work area, and position it as desired.
Note:
You can also double-click the Variable Meter icon to place it on the Procedure work area.
4. Observe the error icons on the Variable Meter in the Properties panel and in the Error list at the bottom
of the screen. This directs you to select a variable for the Variable Meter.
Note:
Except for values in the next step, use the default selections in the Properties window.
5. Enter the following as necessary:
Monitor Display to Track Profile Passes
Value Property
Variable Note:
Click the Variable icon to select the value
from the Variable Selection window.
Pass Counter
24 Label Font Size
24 Value Font Size
For More Information
Adding a Profile Activity on page 78
6.2.9.0 Adding a Monitor Display to Show When Part of the Profile
Plays Out
This task adds a Digital IO Indicator to the test. During the test, the Digital IO Indicator lights when the on light> keyword in the profile plays out, and turns off when the keyword plays out. The
Multipurpose Elite Test Design Guide 81
6.0 Creating Advanced Tests