MTS Multipurpose Elite User Manual
Multipurpose elite test design guide, For mts acumen™ electrodynamic test systems
Table of contents
Document Outline
- 1.0 Technical Support
- 2.0 Preface
- 3.0 Designing a Test
- 3.1.0 Introduction
- 3.2.0 Test Design WorkFlow
- 3.2.1.0 Using the Multipurpose Application with Controller Software
- 3.2.2.0 Creating Tests Overview
- 3.2.3.0 Test Activities Overview
- 3.2.4.0 Working with Test-Run Display Devices
- 3.2.5.0 Test Execution Overview
- 3.2.6.0 Test Design Considerations
- 3.2.7.0 Generating a Report in MP
- 3.2.8.0 Generating a Report Using the Excel Reporter Add-In
- 4.0 Working with Resources
- 5.0 Creating Tests
- 5.1.0 Installing MTS TestSuite Simulation Software
- 5.2.0 Creating Ramp and Cycle Test
- 5.2.1.0 Ramp and Cycle Test Design Overview
- 5.2.2.0 Opening a Station Configuration and Starting the MPE Application
- 5.2.3.0 Creating an Empty Test
- 5.2.4.0 Adding a Ramp Activity
- 5.2.5.0 Adding a Cycle Activity
- 5.2.6.0 Adding a Second Ramp Activity
- 5.2.7.0 Adding a Signal Scope Monitor
- 5.2.8.0 Checking the Test Procedure
- 5.2.9.0 Adding Variables
- 5.2.10.0 Adding an Input Variables Activity
- 5.2.11.0 Adding Parallel Paths and a Data Acquisition Activity
- 5.2.12.0 Running the Test Procedure
- 6.0 Creating Advanced Tests
- 6.1.0 Introduction
- 6.2.0 Working with Profiles
- 6.2.1.0 Profile Test Overview
- 6.2.2.0 Controls That Affect Profiles
- 6.2.3.0 Creating a Profile
- 6.2.4.0 Creating Controller Resource Actions that Map to the Profile
- 6.2.5.0 Starting the MPE Application and Creating a New Test Shell
- 6.2.6.0 Adding a Profile Activity
- 6.2.7.0 Adding a Monitor Display to Show the Profile Waveform
- 6.2.8.0 Adding a Monitor Display to Track Profile Passes
- 6.2.9.0 Adding a Monitor Display to Show When Part of the Profile Plays Out
- 6.2.10.0 Start the Test Procedure and Observe the Response
- 6.2.11.0 Considerations for Profile Design
- 7.0 MTS Controller Software
- 8.0 Appendix A: MPE for MPT Users
- Index