MK Diamond ATS Stand User Manual
Page 16
ATS Stand (ATS Stand Part No. – 156426)
Revision 04/01, Effective Date: April 11, 2001
Page 16
ATS STAND
(Document Part Number 158474)
(S)
Install the Cutting Table
(See the saw Owners Manual)
Install
Cutting Table
(T)
Setup Complete
(R)
Tighten the ATS Stand Support
Plate retaining thumbscrews
as shown
Retaining
Thumbscrew
Rotate
clockwise
to tighten
(Q)
Orient and install the ATS
Stand Support Plate as shown
ATS Stand
Support Plate
(K)
Install one C Bracket and a Bolt
into the top, rear, of the ATS
Stand as shown
(J)
Install one C Bracket and a Bolt
into the top, front, of the ATS
Stand as shown
(L)
Verify all brackets are installed
(N)
Using a 9/16-wrench and socket,
tighten all Bolts
(M)
Install one Nylock nut on the
Bolt of each bracket
(Do not cross-thread the nut)
(O)
Install Water Pan
(P)
Locate the ATS Stand Support
Plate retaining tubes on the back
of the ATS Stand
Fit bracket
over saw frame
Bracket
C
Rotate
clockwise
to tighten
Installation
Direction
(U)
Ensure all bolts are
tight before placing the ATS Stand
in the transport position
Transport
Position
Install into top
rear hole on
right side of stand
Install into top
hole on right side
of stand
Bracket
C
Fit bracket
over saw frame
Bracket
locations
Nylock
nuts
Rotate clockwise
to install
Retaining
Tubes