MK Diamond MK-770 Blade Alignment - Manual

45 Cutting Head Tile Saw- Revision 12/00, Effective Date December 04, 2000 Page-1
45 CUTTING HEAD TILE SAW-BLADE ALIGNMENT PROCEDURE
The Movable Cutting Table of the MK-770 may become misaligned with the Cutting Head of the Tile Saw over
time. Should misalignment occur, perform the following steps to realign the Tile Saw.
NOTE: If alignment problems are the result of a warped blade, a bent frame or bent support arm, or, if alignment
is off by more than 1/8-inch, contact the MK Diamond Service Center – (800) 474-5594
Tools Needed:
Preparation:
1/2-inch Wrench or
MK Open End Wrench and
MK Triple Hole Box Wrench
Combination Square (Square)
12-inch or Greater
(A)
Remove Tile Saw
from Power Source
(C)
Inspect Tile Saw
for damage
(D)
Inspect Diamond Blade
for damage
(B)
Remove Water Pan
Disconnect Saw
Remove Pan
Inspect
Blade
Inspect Frame
Flat Head Screwdriver
Metal Straight Edge 1/4-inch Wrench
Inspect Cutting Head
Inspect Cutting Table