Metal Sales Pro-Panel II Installation - Manual (Page 27)

© Metal Sales Manufacturing Corporation / Subject to change without notice / Effective 5/09.
26
POST FRAME
& RESIDENTIAL
PANCAKE HEAD WOODSCREW SIZE TYPE FINISH APPLICATION
#10-12 x 1" A Plated Panel or Flashing to
wood substructure
FASTENER SELECTION GUIDE
POP RIVET SIZE TYPE FINISH APPLICATION
1 /
8
" x 3 /
16
" A Unpainted Flashing to Panel,
Flashing to Flashing
1 /
8
" x 3 /
16
" A Painted Flashing to Panel,
Flashing to Flashing
#9-15 x 1" A Painted Panel or Flashing
#9-15 x 1 1 /
2
" A Painted to wood substructure
#9-15 x 2" A Painted
WOODSCREW SIZE TYPE FINISH APPLICATION
# 1 /
4
- 14 x 7 /
8
" Stitch Painted Flashing to Panel,
Flashing to Flashing,
Panel Sidelap
STITCH SCREW SIZE TYPE FINISH APPLICATION
5'-0"
MINIMUM
Length - Minimum factory cut length is 5'-0" on panels. Panels over 45'-0" require additional consideration in packaging,
shipping, and erection. Please consult Metal Sales for recommendations.
There are two critical measurements involving metal panels: the length of panel overhang required at the eave, and the peak
end. In each case a certain measurement is required. Check each measurement to ensure panel placement gives you the dis-
tance required at the eave, and peak condition. In most cases any variance can be taken out at the eave or peak ends.
PANEL