Bryant LEGACY 580J - Manual (Page 5)

5
Table 1 – FACTORY--INSTALLED OPTIONS AND FIELD--INSTALLED ACCESSORIES
CATEGORY ITEM
FACTORY
INSTALLED
OPTION
FIELD
INSTALLED
ACCESSORY
Cabinet
Dedicated Vertical Air Flow Duct Configuration X
Dedicated Horizontal Air Flow Duct Configuration X
Thru---the---base electrical or gas---line connections X
Coil Options
Cu/Cu (indoor) coils X
Pre---Coat (outdoor) coils X
E---coated (outdoor & indoor) coils X
Humidity Control Perfect Humidity™ Dehumidification System X
Condenser Protection Condenser coil hail guard (louvered design) X X
Controls
Thermostats, temperature sensors, and subbases X
RTU Open protocol controller X
Smoke detector (supply and/or return air) X X
Time Guard II compressor delay control circuit X
Phase Monitor X
Economizers
& Outdoor Air
Dampers
EconoMi$ert IV (for electro---mechanical controlled RTUs) X X
EconoMi$ert2 (for DDC controlled RTUs) X X
Motorized 2 position outdoor---air damper X X
Manual outdoor---air damper (25%) X X
Barometric relief 1 X X
Barometric hood (Horizontal economizer) X
Power exhaust–centrifugal blower X X
Economizer Sensors
&
IAQ Devices
Single dry bulb temperature sensors 2 X X
Differential dry bulb temperature sensors 2 X
Single enthalpy sensors 2 X X
Differential enthalpy sensors 2 X
Wall or duct mounted CO
2
sensor 2 X
Unit mounted CO
2
sensor 2 X
4---in Filter Track Assembly X
Gas Heat
Propane conversion kit X
Stainless steel heat exchanger X
High altitude conversion kit X
Flue Discharge Deflector X
Indoor Motor & Drive Multiple motor and drive packages X
Low Ambient
Control
Winter start kit 3 X
Motormaster head pressure controller 3 X
Power
Options
Convenience outlet (powered) X
Convenience outlet (unpowered) X
Non---fused disconnect 4 X
Roof Curbs
Roof curb 14---in (356mm) X
Roof curb 24---in (610mm) X
NOTES:
1. Included with economizer.
2. Sensors used to optimize economizer performance.
3. See application data for assistance.
4. Non---fused disconnect switch cannot be used when MOCP electrical rating exceeds 70 amps at 460/575 volt and 150
amps at 208/230 volt. Bryant Packaged RTUBuilder selects this automatically.
580J