Assembly – Marshalltown SG87SH SURFACE SHARK Floor Grinder User Manual
Page 12

PAGE 12
SG87Sh SuRFACE ShARK FLooR GRINDER
ASSEMBLY
The SG87Sh Floor Grinder is shipped from the factory
secured on a specially designed wooden pallet and
protected from external damage by a corrugated
carton or wood crate. If shipped with a corrugated
carton, the Floor Grinder can be secured to the pallet
by wood laths nailed to the pallet body. Remove the
carton or crate immediately upon receipt using suitable
tools to remove the nails.
REMOVING THE FLOOR GRINDER FROM THE
PALLET
Application: SG87SH SURFACE SHARK
Tools Required:
1 each, pliers.
1 each, claw hammer or a hammer and an
appropriate pry bar.
The Floor Grinder is secured to the pallet with steel
banding. using the pliers, cut and remove the banding.
The Floor Grinder can then be removed from the
pallet.
WEAR SAFETY GLASSES AND OTHER
APPROPRIATE SAFETY APPAREL WHEN CUTTING
THE STEEL BANDING AND/OR REMOVING THE
CORRUGATED/WOOD SHIPPING CRATE.
visually inspect the shipment for freight damage
and/or missing parts. If shipping damage is evident,
contact the delivering carrier immediately to arrange
for an inspection of the damage by their claims
representative. Federal law requires that a claim be
filed within a specific time period. If missing parts
are detected, notify your dealer who will assist you in
obtaining them.
The Floor Grinder is shipped from the factory completely
assembled. If ordered with the Floor Grinder, multi-
accessory attachments can be shipped separately to
minimize the potential for loss during shipment.
Check all fasteners for proper security. Consult a
fastener torque chart for the proper torque value if any
fastener is found to require retorquing.
The Safety and Dust Shield Assembly Kit is included
as a standard feature. The Safety and Dust Shield is
designed to perform the following job functions:
1) To contain loose materials within the platform area
of the Floor Grinder as a direct result of a specific
process. This includes materials removed from the
surface as well as any slurry mixture utilized to help
maximize material removal efficiencies.
2) To provide a method for a vacuum system to
help remove airborne, dust-related materials from
within the skirt assembly. Dust related materials are
usually created as a result of any specific process.
A specific job application may require the reduction
and/or minimization of airborne dust related materials
from the atmosphere while the Floor Grinder is being
operated. The kit includes a hose and necessary
hardware to connect the skirt assembly to the 3 inch
diameter vacuum attachment fitting located at the rear
of the machine. use of the kit along with a suitable
vacuum system will not completely remove all airborne
and loose materials directly from the work surface.
THE SAFETY AND DUST SHIELD ASSEMBLY KIT IS
RECOMMENDED FOR USE WHERE AND/OR WHEN
PERMITTED ON SPECIFIC JOB APPLICATIONS TO
MAXIMIZE OVERALL SAFETY AND PRODUCTIVITY.
FINAL DISCRETION IS THE RESPONSIBILITY OF
THE OWNER(S) AND/OR OPERATOR(S).
THE USE OF THE SAFETY AND DUST SHIELD
ASSEMBLY KIT ALONG WITH A SUITABLE
VACUUM SYSTEM TO REMOVE HAZARDOUS
CLASSIFIED, AIRBORNE MATERIALS FROM
THE WORK SURFACE WILL NOT ELIMINATE
THE REQUIREMENT FOR PROPER SAFETY
RELATED EQUIPMENT, OPERATING PLAN AND/
OR PROCEDURES.
USE OF THE SAFETY AND DUST SHIELD
ASSEMBLY KIT ALONG WITH A SUITABLE
VACUUM SYSTEM WILL NOT COMPLETELY
REMOVE ALL LOOSE MATERIALS FROM THE
WORK SURFACE. HAZARDOUS CLASSIFIED,
LOOSE MATERIALS MUST BE REMOVED FROM
THE WORK SURFACE BY PROCESSES AND/OR
PROCEDURES MEETING THE APPLICABLE OSHA
AND/OR EPA REQUIREMENTS.