Lenze 931W - Manual (Page 19)

Software implementation and parameter setting
Setup menu
Operating modes
5

19 HB 13.0001-EN 3.0
5 Software implementation and parameter setting
5.1 Setup menu
In this menu the access authorisations are defined, the operating level is specified, and the
parameters of the RS232 interface are set.
Before the other menu pages can be used, communication with the drive first has to be
established via this menu page. Via the operating level that is selected and permitted in
this menu, the authorisation level or the access authorisations are automatically defined.
pÉíìé
5.1.1 Operating modes
Offline
In this operating mode, the servo inverter is disconnected from the RS232 interface. A
programming process may be effected in the offline status, though for transmission to the
motor has to be saved on the PC by means of ”Save configuration” and be transferred to
the inverter in online operation by means of the function ”Load configuration”.
Online level 1
The system is online from level 1. In this level, however, it can only be observed. This level
serves to analyse the status of the drive system. If the inverter is controlled by means of a
bus system (CAN, Profibus), important data can be observed.