Lenze 931W - Manual (Page 10)

Safety instructions
General safety and application notes for Lenze servo inverters
2

10 HB 13.0001-EN 3.0
Application as directed
Drive controllers are components designed for installation into electrical systems or
machines. They are not household appliances, but are only designed as components for
industrial or professional purposes in terms of EN 61000-3-2.
When installing the controllers into machines, commissioning (i.e. starting operation
asdirected) is prohibited until it is proven that the machine complies with the regulations
of the EC Directive 98/37/EC (Machinery Directive); EN 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when there is
compliance with the EMC Directive (89/336/EEC).
The technical data and information on connection conditions can be obtained from the
nameplate and the documentation. They must be observed in any case.
Warning: The availability of controllers is restricted according to EN 61800-3. These
products can cause radio interferences. In this case, special measures are required.
Transport, storage
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions in accordance with EN 50178.
Installation
The controllers must be installed and cooled according to the instructions given in the
corresponding documentation.
Ensure proper handling and avoid mechanical stress. Do not bend any components and do
not change any insulation distances during transport or handling. Do not touch any
electroniccomponents and contacts.
Controllers contain electrostatically sensitive components, which can easily be damaged
by inappropriate handling. Do not damage or destroy any electrical components, since this
might endanger your health!
Electrical connection
When working on live controllers, the valid national regulations for the prevention of
accidents (e. g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate regulations
(e.g. cable cross-sections, fuses, PE connection). Additional information can be obtained
from the documentation.
The documentation contains notes for the installation according to EMC (shielding,
earthing and running of the cables). Also observe these notes with regard to CE-labelled
drive controllers. The manufacturer of the system or machine is responsible for the
compliance in accordance with the limit values required in connection with EMC
legislation.